Built-in rinse aid dispenser with automatic initial and continuous cycle loading
Deep drawn pressed wash tank with fully rounded corners, sloped towards the drain to prevent dirt build up provides fast drainage in only a few minutes
Pressed wash tank with no welded points offer a guaranteed water tight solution
Low noise level.
120 seconds cycle
Raise incoming water to a guaranteed minimum temperature of 82°C for sanitizing rinse
Maximum capacity of 30 racks per hour
Equipped with single phase electrical cable and Schuko plug for easy and fast installation
Washing system endowed with rotating washing arms from both top and bottom, high powered wash pump and large capacity wash tank
Easy service access to main components without moving the unit
Optional rinse booster pump available to be installed on site
Completely closed on the back by a cover plate
Unit to feature rinse aid dispenser pump
Wash/rinse arms and nozzles in stainless steel
Finished in top quality stainless steel with double skinned construction to aid durability and reduce noise
Internal components (arms and filter) are easy extractable
304 AISI stainless steel front panel, load bearing frame, wash tank, wash and rinse arms
Simple operation control panel
Insulated double skin door construction preserves heat inside the tank to lower energy consumption and the noise
Counter-balance mechanism minimizes impact when opening and closing